|
|
1251 datasets found! (Query time: 2 ms)
<< PREV | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | NEXT >>
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Interstitial water geochemistry results of IODP Hole 386-M0091A
| Abstract: |
Results of interstitial water (IW) geochemistry analyses from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan, followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. Sampling for IW geochemistry took place offshore immediately upon core recovery using Rhizon samplers. A total amount of approximately 15 mL IW per sample were extracted from the core sections over a maximum rhizon retention time of 6 hours. IW main samples were subsequently split into as many as seven fractions for the following IODP standard measurements: sulfide (1.5 mL IW + 0.6 mL ZnAc 2.5%), salinity (0.5–1.5 mL), pH and alkalinity (3–4 mL), ammonium (0.5–1.5 mL), cations (3 mL IW + 0.03 mL HNO3), and anions (3 mL). […] |
| Size: |
80 data points |
https://doi.org/10.1594/PANGAEA.979663 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Color Reflectance (Spectrophotometer) of IODP Hole 386-M0095A
| Abstract: |
Color reflectance spectrophotometry and colorimetry data from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The data where obtained during the onshore phase of expedition 386 which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu. After longitudinal splitting of the core sections, each archive half was scanned by the Tri-Sensor Core Logger (TSCL; NS Design) including a noncontact imaging spectrophotometer (MetaVue VS3200; X-Rite), recording data at 2-cm sampling interval. The obtained data is represented in the L*a*b* color coordinate system, where L* is a total reflectance index ranging 0%–100%, a* is green (<0) to red (>0) chromaticity, and b* is blue (<0) to yellow (>0) chromaticity. L*a*b* values were transferred into RGB values using the MATLAB routine lab2rgb. […] |
| Size: |
1406 data points |
https://doi.org/10.1594/PANGAEA.975205 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Description of lithologic section units of IODP Hole 386-M0091D
| Abstract: |
Description of lithologic section units from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The content of this dataset is based on the visual core descriptions (VCD) done by sedimentologists during the onshore phase of expedition 386 (2022-02-14 – 2022-03-15 onboard D/V Chikyu). For digitalization of the information, content of the hand-drawn VCD sheets was transferred into the Drilling Information System database. The present dataset forms the basis for the digital lithologic columns and composite plots archived under the titles "Visual core description of IODP Hole 386-M0091D". […] |
| Size: |
1879 data points |
https://doi.org/10.1594/PANGAEA.978137 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Shear strength (handheld penetrometer) from IODP Hole 386-M0091B
| Abstract: |
Shear strength from handheld penetrometer of the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). This dataset was obtained at the end of the core processing workflow during the third phase (Personal Sampling Party, PSP) of expedition 386, which took place between 2022-11-15 – 2022-11-30 onboard D/V Chikyu. Measurements were performed on the work halves of core sections using a handheld (pocket) penetrometer equipped with a 10 mm diameter tip. The tip was pushed 6.3 mm perpendicular to the split core surface with the measuring pin downward until the groove marked on the tip was even with the level of the core surface. The resulting resistance (compressive strength) was read from the device and used to calculate undrained shear strength. At each measurement depth, three measurements were conducted and the resulting undrained shear strength averaged. […] |
| Size: |
40 data points |
https://doi.org/10.1594/PANGAEA.977749 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0085A
| Abstract: |
P-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers). […] |
| Size: |
3 data points |
https://doi.org/10.1594/PANGAEA.975288 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Shear strength (fall cone) from IODP Hole 386-M0083C
| Abstract: |
Undrained shear strength data from fall cone testing of the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). This dataset was obtained at the end of the core processing workflow during the third phase (Personal Sampling Party, PSP) of expedition 386, which took place between 2022-11-15 – 2022-11-30 onboard D/V Chikyu. Measurements were performed on the work halves of core sections at an interval of approx. 1 meter using an ELE International fall cone penetrometer (STANDARD BS1377) with the following cone specifications: 35 mm cone, 30 degrees angle, around 30 g, stainless steel, 3.25 (+/-0.05) mm rod diameter. The fall cone penetrometer measures the penetration of a cone as it free falls and embeds itself in the sediment. During testing, the cone (pointing downward) was lowered, so that it just touched the surface of the split core before it was locked in place with the dial gauge reading noted. […] |
| Size: |
6 data points |
https://doi.org/10.1594/PANGAEA.975418 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Core close-up images of IODP Hole 386-M0082C
| Abstract: |
Collection of split cores' close-up images from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan. Images were obtained during the onshore phase of the expedition, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu. Close-up photos were taken utilizing a standard photo camera by sedimentologists during visual core description. Decision on imaged intervals was subject to the core describers in charge. […] |
| Size: |
10 data points |
https://doi.org/10.1594/PANGAEA.976332 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Physical properties (MSCL) of IODP Hole 386-M0081E
| Abstract: |
Multi-Sensor Core Logger (MSCL) data (P-wave velocity, gamma ray attenuation (GRA) density, magnetic susceptibility, natural gamma radiation (NGR), noncontact resistivity (NCR)) from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). These data were obtained from whole round core sections by means of a Geotek MSCL during the offshore phase of the expedition. The offshore phase of expedition 386 took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan. As the aforementioned parameters are sensitive to temperature core sections were stored for at least 6 hours after arrival on deck before measurement to allow for temperature equilibration. The core physical properties were measured at predetermined optimal instrument-based spatial and temporal sampling intervals. […] |
| Size: |
198 data points |
https://doi.org/10.1594/PANGAEA.974887 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Description of lithologic section units of IODP Hole 386-M0085D
| Abstract: |
Description of lithologic section units from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The content of this dataset is based on the visual core descriptions (VCD) done by sedimentologists during the onshore phase of expedition 386 (2022-02-14 – 2022-03-15 onboard D/V Chikyu). For digitalization of the information, content of the hand-drawn VCD sheets was transferred into the Drilling Information System database. The present dataset forms the basis for the digital lithologic columns and composite plots archived under the titles "Visual core description of IODP Hole 386-M0085D". […] |
| Size: |
3427 data points |
https://doi.org/10.1594/PANGAEA.978112 - Score: 6.193
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Shear strength (fall cone) from IODP Hole 386-M0088C
| Abstract: |
Undrained shear strength data from fall cone testing of the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). This dataset was obtained at the end of the core processing workflow during the third phase (Personal Sampling Party, PSP) of expedition 386, which took place between 2022-11-15 – 2022-11-30 onboard D/V Chikyu. Measurements were performed on the work halves of core sections at an interval of approx. 1 meter using an ELE International fall cone penetrometer (STANDARD BS1377) with the following cone specifications: 35 mm cone, 30 degrees angle, around 30 g, stainless steel, 3.25 (+/-0.05) mm rod diameter. The fall cone penetrometer measures the penetration of a cone as it free falls and embeds itself in the sediment. During testing, the cone (pointing downward) was lowered, so that it just touched the surface of the split core before it was locked in place with the dial gauge reading noted. […] |
| Size: |
3 data points |
https://doi.org/10.1594/PANGAEA.975439 - Score: 6.193
<< PREV | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | NEXT >>
|
