|
1251 datasets found! (Query time: 24 ms)
<< PREV | 89 | 90 | 91 | 92 | 93 | 94 | 95 | 96 | 97 | 98 | 99 | 100 | 101 | 102 | 103 | 104 | 105 | 106 | 107 | 108 | NEXT >>
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Foraminifera occurrences of IODP Hole 386-M0090C
Abstract: |
Results of Foraminifera assemblage analyses from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan, followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, micropaleontology samples were taken from the end of split cores at 5 m intervals. During the onshore phase approximately 2 cubic centimetres of sediment from each of these samples were analysed for foraminifera. After drying overnight in a ~40°C oven, samples were disaggregated in a solution of deionized water, Calgon, and H2O2 to ensure removal of clay-sized particles. Samples were then wet sieved through a 63 μm mesh sieve and rinsed with deionized water. The coarse fraction was placed on filter paper in an oven at ~40°C until it dried completely. […] |
Size: |
45 data points |
https://doi.org/10.1594/PANGAEA.979412 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0084E
Abstract: |
P-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers). […] |
Size: |
3 data points |
https://doi.org/10.1594/PANGAEA.975286 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Smear slide descriptions of IODP Hole 386-M0081D
Abstract: |
Descriptions of smear slides from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan. This was followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, smear slides were prepared from paleontology samples collected with a tip-cut syringe from section ends every 5 m. During the onshore phase, smear slides samples were collected every 2 m to complement visual core description observations and identify the composition of fine-grained sediment. The smear slides were prepared by putting a small amount of sediment on a glass slide mixed with distilled water. The slide was subsequently evaporated on a hot plate, and the dried sample was mounted in Norland Optical Adhesive 61 using ultraviolet light. […] |
Size: |
736 data points |
https://doi.org/10.1594/PANGAEA.978703 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Smear slide descriptions of IODP Hole 386-M0087A
Abstract: |
Descriptions of smear slides from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan. This was followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, smear slides were prepared from paleontology samples collected with a tip-cut syringe from section ends every 5 m. During the onshore phase, smear slides samples were collected every 2 m to complement visual core description observations and identify the composition of fine-grained sediment. The smear slides were prepared by putting a small amount of sediment on a glass slide mixed with distilled water. The slide was subsequently evaporated on a hot plate, and the dried sample was mounted in Norland Optical Adhesive 61 using ultraviolet light. […] |
Size: |
35 data points |
https://doi.org/10.1594/PANGAEA.978728 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Foraminifera occurrences of IODP Hole 386-M0083E
Abstract: |
Results of Foraminifera assemblage analyses from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan, followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, micropaleontology samples were taken from the end of split cores at 5 m intervals. During the onshore phase approximately 2 cubic centimetres of sediment from each of these samples were analysed for foraminifera. After drying overnight in a ~40°C oven, samples were disaggregated in a solution of deionized water, Calgon, and H2O2 to ensure removal of clay-sized particles. Samples were then wet sieved through a 63 μm mesh sieve and rinsed with deionized water. The coarse fraction was placed on filter paper in an oven at ~40°C until it dried completely. […] |
Size: |
48 data points |
https://doi.org/10.1594/PANGAEA.979367 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Smear slide microscopy images of IODP Hole 386-M0084E
Abstract: |
Collection of smear slide microscopy images from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan. This was followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, smear slides were prepared from paleontology samples collected with a tip-cut syringe from section ends every 5 m. During the onshore phase, smear slides samples were collected every 2 m to complement visual core description observations and identify the composition of fine-grained sediment. The smear slides were prepared by putting a small amount of sediment on a glass slide mixed with distilled water. The slide was subsequently evaporated on a hot plate, and the dried sample was mounted in Norland Optical Adhesive 61 using ultraviolet light. […] |
Size: |
12 data points |
https://doi.org/10.1594/PANGAEA.976785 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Foraminifera occurrences of IODP Hole 386-M0088C
Abstract: |
Results of Foraminifera assemblage analyses from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan, followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, micropaleontology samples were taken from the end of split cores at 5 m intervals. During the onshore phase approximately 2 cubic centimetres of sediment from each of these samples were analysed for foraminifera. After drying overnight in a ~40°C oven, samples were disaggregated in a solution of deionized water, Calgon, and H2O2 to ensure removal of clay-sized particles. Samples were then wet sieved through a 63 μm mesh sieve and rinsed with deionized water. The coarse fraction was placed on filter paper in an oven at ~40°C until it dried completely. […] |
Size: |
29 data points |
https://doi.org/10.1594/PANGAEA.979385 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Foraminifera occurrences of IODP Hole 386-M0082B
Abstract: |
Results of Foraminifera assemblage analyses from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan, followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. During the offshore phase, micropaleontology samples were taken from the end of split cores at 5 m intervals. During the onshore phase approximately 2 cubic centimetres of sediment from each of these samples were analysed for foraminifera. After drying overnight in a ~40°C oven, samples were disaggregated in a solution of deionized water, Calgon, and H2O2 to ensure removal of clay-sized particles. Samples were then wet sieved through a 63 μm mesh sieve and rinsed with deionized water. The coarse fraction was placed on filter paper in an oven at ~40°C until it dried completely. […] |
Size: |
138 data points |
https://doi.org/10.1594/PANGAEA.979361 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): Shear strength (handheld penetrometer) from IODP Hole 386-M0090C
Abstract: |
Shear strength from handheld penetrometer of the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). This dataset was obtained at the end of the core processing workflow during the third phase (Personal Sampling Party, PSP) of expedition 386, which took place between 2022-11-15 – 2022-11-30 onboard D/V Chikyu. Measurements were performed on the work halves of core sections using a handheld (pocket) penetrometer equipped with a 10 mm diameter tip. The tip was pushed 6.3 mm perpendicular to the split core surface with the measuring pin downward until the groove marked on the tip was even with the level of the core surface. The resulting resistance (compressive strength) was read from the device and used to calculate undrained shear strength. At each measurement depth, three measurements were conducted and the resulting undrained shear strength averaged. […] |
Size: |
4 data points |
https://doi.org/10.1594/PANGAEA.977746 - Score: 5.95
-
Strasser, M; Ikehara, K; Everest, JD et al. (2025): X-ray CT images of IODP Hole 386-M0090A
Abstract: |
Collection of X-ray Computed Tomography (CT) images from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The offshore phase of this expedition took place between 2021-04-13 and 2021-06-01 onboard Japanese R/V Kaimei from and to Yokosuka, Japan. This was followed by an onshore phase onboard D/V Chikyu between 2022-02-14 – 2022-03-15. X-ray CT scanning was performed on whole-round sections on board D/V Chikyu in July 2021, after the offshore phase and prior to the onshore phase, using a Discovery CT 750HD (GE Medical Systems) that produces 32 0.625 mm thick slice images every 0.4 s. Data generated for each core consist of core-axis-normal planes of X-ray attenuation values that are 512 × 512 pixels in size. Data were stored on the server as DICOM formatted files. The DICOM files were restructured to create 3-D images for further investigation. […] |
Size: |
4 data points |
https://doi.org/10.1594/PANGAEA.977590 - Score: 5.95
<< PREV | 89 | 90 | 91 | 92 | 93 | 94 | 95 | 96 | 97 | 98 | 99 | 100 | 101 | 102 | 103 | 104 | 105 | 106 | 107 | 108 | NEXT >>
|